The diff nut clamp replaces the M3 nyloc diff tension nut. This allows the diff tension to be adjusted
by removing only the right hand wheel.
Adjustment is then achieved by simply loosening the locking grub screw and holding the 1.5mm driver in place at the same time as turning the left wheel/other side of the diff.
Finally, tighten the locking grub screw and put the wheel back on.
Vi bruker cookies på våre nettsider. Dette handler, som du kanskje allerede har skjønt, ikke om søte småkaker – et mer beskrivende norsk ord for cookies er informasjonskapsler. En cookie er en liten tekstfil som lagres på nettleseren din når du besøker våre nettsider.Greit for meg!