Beskrivelse
Low ball studs are 0.5mm lower.
Long Thread Length– 8mm
Ball Diameter 4.3mm
Low ball studs are 0.5mm lower.
Long Thread Length– 8mm
Ball Diameter 4.3mm
Vekt | 25 g |
---|
This Touring Car Wheel Arch Cutting Jig is a must for any Touring Car Racer.
The jig ensures accurate and repeatable cutting out of wheel arches time after time. One of the most tricky parts of body prep is now made super simple.
– Simply set your car to the required ride height and position the body shell to your desired height.
– Position the jig flush with the outside of the body shell and locate the centre of the axle through the hole in the tool. The end radius is different from side to side to prevent body tucks so ensure the jig’s orientation is correct.
– Hold the jig and draw round the inside with a fine marker pen and then carefully cut to the line with a pair of curved scissors.
– The jig can also measure wing overhang with the handy 10mm step.
Schumacher Bearing Guidlines
Yellow = ABEC5, oil filled, shielded, steel balls recommended for relatively clean conditions. Schumacher On Road cars kit specification.
Red = ABEC5, grease filled, double rubber seals, steel balls recommended for wet or dirty conditions. Schumacher Off Road cars kit specification.
Orange or Grey = ABEC 5, oil filled, shielded, extra hard ceramic balls for higher efficiency. Recommended for On Road.
Black = Pro High Precision German or Japanese manufactured, rubber seal. Recommended for Off Road.
Metal = Pro High Precision German or Japanese manufactured, shielded. Recommended for On Road.